Specifications
Chuck Dia.: No Specs Attached inches
Spindle (Horz/Vert): No Specs Attached
Power: No Specs Attached horsepower
Swing: No Specs Attached inches
Under Wheel: No Specs Attached inches
Table Speeds: No Specs Attached
Grinding Wheel Width: No Specs Attached inches
Table Motor Horsepower: No Specs Attached horsepower
Grinding Wheel Dia.: No Specs Attached inches
CNC Control: No Specs Attached
Type of CNC Control: No Specs Attached
Dimensions: No Specs Attached
Weight: No Specs Attached ounces
Standard Specifications - SUBJECT TO VERIFICATION
36" Magnetic Chuck Diameter, Approximately .200" Chuck Life
18" Approximate Range Over Chuck With New Wheel
18" Diameter of Wheel Chuck, Segmented Style
(6) Ranges of Chuck Speeds, 6, 9, 12, 18, 25, 33 RPM
Feed 0.004 - 0.080 IPM
720 RPM Wheel Speed
(6) Ranges of Chuck Speeds 6,9,12,18,25 & 33 RPM
30 HP- 3 Phase, 60 Cycle, 208 Volt
Floor Space: 129"L x 60"W
Height: 7'1" Min., 8'2" Approximate Max.
Approx. Weight: 14,500 lbs
Equipped with:
Wet Base design
Coolant pump and piping
Magnetic Chuck controls
Wheel Dresser
Scope of work to be completed prior to sale:
Rebuild Spindle
New Elevating Screw & Nut w/ all new bearings
Rebuild Dresser Arm Assembly
Replace Coolant Lines
New Box Ways
Clean up Electrical Panel
Replace Seal and Flush Upper Gear Box
Remove Table Drive Transmission and Flush Lube Ports
Scrape and Flake Saddle
Replace Lube Lines on Saddle
New Automatic Lube Pump
Clean and Paint
Tram Head In
Documented Test Grind Results