Search...

Specifications

Chuck Dia.: No Specs Attached inches
Spindle (Horz/Vert): No Specs Attached
Power: No Specs Attached horsepower
Swing: No Specs Attached inches
Under Wheel: No Specs Attached inches
Grinding Wheel Width: No Specs Attached inches
Grinding Wheel Dia.: No Specs Attached inches
CNC Control: No Specs Attached
Type of CNC Control: No Specs Attached
Dimensions: No Specs Attached
Weight: No Specs Attached ounces
Table Speeds: No Specs Attached
Table Motor Horsepower: No Specs Attached horsepower
Spindle Motor: 15HP, 240/480 volt
Range: 20" Diameter x 9" Vertical over Chuck
Chuck: 20" Diameter,
Chuck Speeds: 15, 24, 41, 64 RPM
Grinding Wheel:New Cortland Segmented Chuck and Clamps
Grinding Wheel Speed: 1200 RPM
Feeds: .003 - .070 IPM
Automatic lube systems
Standard Coolant System (Paper Filtration system available)
Floor Space: 5'3"L x 3'6"W x 6' 8-3/4"Max./5' 9-1/2"Min.H
Approx. Weight: 7200 lbs

The scope of work is as follows:

 Clean up electrical (Replace a could overloads)

Replace Coolant Lines

Replace Water Guards

Clean and Paint

Tram Head to Table

Test Run for 8 Hours.